TMW T13 Stretch Multi-Cut

 Material Type                      Any Type
 Gauge Range                        0.010" to 0.142"

 Width                                     3" to 74"
 Width Tolerance                 +/-0.005"

 Part Length                          3" to 192" multi-cut
                                                to 320" edge trim
 Length Tolerance               +/- 0.005"

 Trim per Side                       0.250" to 2"
 Minimum Slit Width            3"

 Coil Information
  max. weight                           50,000 lbs.
  max. O.D.                               84"
  max. I.D.                                 35.25"
  min. I.D.                                  19"
  yield at max. gauge                60,000 psi max.

 Max. Stack Weight              15,000 lbs.
           TMW T18 Cut-to-Length

 Material Type                      Any Material
 Gauge Range                        0.043" to 0.312"
                                                to 0.375" (see note)
 Width                                     3" to 74"
 Width Tolerance                 mill edge

 Part Length                          3" to 320"
 Length Tolerance               +/- 0.005"

 Coil Information
  max. weight                           80,000 lbs.
  max. O.D.                               84"
  max. I.D.                                 35.25"
  min. I.D.                                  20"

 Max. Stack Weight              20,000 lbs.

 Note: max. yield -         80,000 psi to 0.312" x 74"
                                      55,000 psi to 0.375" x 60"


TMW’s Stretchers are a unique solution for transforming material with significant stress and edge wave into perfectly flat, stress-free blanks. In fact, we guarantee the material we stretch:

   - will beat temper pass CTL for flatness,
   - will achieve 1/4 of ASTM A568 Table 15
      tolerances after laser cutting,

or TMW's processing is free.

This matters to fabricators. Roller-leveled blanks are flat, but still contain stress. When the blank is cut or welded, this stress causes 'springback' which deflects both the cut part and the blank. Blanks leveled on a TMW Stretcher have no residual stress and no springback. That reduces scrap.